|
 
SYNROOF is suitable for application to
most types of roofs, flat or pitched eg., concrete, metal, asbestos,
wood etc. It also forms a heat and solar reflecting membrane.
 Strong
and flexible.
Excellent adhesion to
substrate.
Vapour permeable.
Resistant to aging and
UV radiation.
Designed to be used in
the Middle East climatic conditions.
Single pack.
Labour saving.
Safe, non-flammable,
non-toxic.
Easy to apply.
By soft bristle brush, roller or airless spray. Minimum 1
mm thick dry film is recommended for a satisfactory performance and
perfect recoating interval is 8 hours at 30 Deg. C., 65% RH.
Bitumen
or asphalt roof surfaces to receive a coating of SYNROOF should
thoroughly dry.
Never apply if rain is
imminent.
Application at
temperatures below +5° C may result in incomplete film formation, with
reduced elasticity and the possibility of cracks forming
Do not use SYNROOF on
areas that will be constantly submerged in water.
Traffic
roofs : Maximum protection can be achieved by insitu screed. Use a
Kraft paper or polyethylene separation layer over the insulation boards.
Then lay a topping screed of 4 cm to 5 cm thickness.
Non-Traffic
roofs : Place a non woven polyester separation layer (Alyaf or
similar) over the insulation boards. Then cover to a minimum depth of 5
cm with 15/30 gauge washed gravel. For thicker insulation boards, the
gravel depth should at least be equal to that of the board thickness
|
Clean with kerosene
Hands : Use a hand cleaner or kerosene followed by soap and water.
1 Sq. mtr/kg to obtain 500 micron dry film thickness.
SYNROOF is tested as per ASTM test methods and report is
available on specific request.
20 kg. metal pail.
Store under cover at temperature above 5° C. and below
30° C. Minimum shelf life of one year in unopened containers can be
expected.
Satin white and grey.
Allow 24 hours for the final curing to take place at
normal working temperatures. Complete curing is required before any
insulation or protection board is placed.
Generally safe, non-toxic and non-flammable whilst
wet. However, avoid prolonged skin contact. Use of cream, gloves is
advisable. If eyes are affected by SYNROOF, rinse with copious amount of
clean water. If ingested, seek medical attention immediately.
Roof and other surfaces must be thoroughly clean, dry, free from moss,
dirt, oil, grease and loosely adhering materials. In case of metal
surfaces, remove rust and contamination and apply a coat of
anti-corrosive primer. To achieve best results, a fiber mesh reinforcing
mat should be embedded into first coat of SYNROOF whilst still wet
mainly at expansion areas and joints with parapet. Depending on the
nature of substrate, a priming coat with SYNROOF diluted with 20% water
may be required.
|
